Water Filter Profine Silver Small

Product detailed description

Profine® SILVER provides fine filtration for food-grade water.

Profine® SILVER removes unpleasant odors and tastes, reduces chlorine, and offers a nominal filtration level of 0.5 microns. This single-use quick-connect cartridge is made with extruded carbon block technology enhanced with silver for a bacteriostatic effect. It is a composite structure cartridge suitable for treating potable water in compliance with DM 25/2012.

Removes bad taste, odors, chlorine, dirt, rust, invisible suspended particles, mold, and algae. Reduces aluminum, ammonium (NH4), iron, and sulfate.

• Ideal for: safe drinking and cooking.
• Improves: the taste of beverages, sparkling water, and post-mix systems.
• Protects: against clogs, corrosion, and wear.
• No electrical power required.
• Installation: vertical or horizontal.
• The quick-change cartridge is easy to install and replace without special tools.

The Profine SILVER range, with antimicrobial protection, inhibits potential bacterial growth.

Features:

• Chlorine reduction
• Bacteriostatic effect
• Reduction of suspended particulates

Specifications:

• Technology: Carbon Block (CB)
• Filtration density: 0.5 microns
• Capacity: Based on model, see table below.

  MINI | SMALL | MEDIUM | LARGE Flow Rate 2.2 l/min * 3 l/min * 5 l/min * 7 l/min * Capacity 7,000 l * 10,000 l * 15,500 l * 45,000 l * Operating Pressure Min. 2 – Max. 6 Bar Min. 2 – Max. 6 Bar Min. 2 – Max. 6 Bar Min. 2 – Max. 6 Bar Temperature Min. 4 – Max. 30°C Min. 4 – Max. 30°C Min. 4 – Max. 30°C Min. 4 – Max. 30°C

Activation: Run water through the filter at maximum pressure and flow for at least 5 minutes to purge air from the filter.

Cartridge Replacement: Replace when capacity is reached or when flow slows (below 0.7 bar/10 psi), approximately every 6 months, but at least annually.

Note: Do not use where water is microbiologically unsafe or of unknown quality without adequate pre- and post-system disinfection. Certified contaminant reduction systems may be used with disinfected water containing filterable contaminants. All systems must be maintained according to manufacturer instructions.